P0131

Wiring Diagram:

CIRCUIT DESCRIPTION
Refer to Air/Fuel ratio feed back compensation (Closed Loop System).

Detecting Condition / Possible Cause:

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester.

1. Turn ignition switch OFF. Clear DTC with ignition switch ON, check vehicle and environmental condition for:
- Indication of fuel level meter in combination meter: 1/4 or more (For 1999 MY)
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
- Ambient temp.: -10 °C, 14 °F or higher
- Intake air temp.: 70 °C, 158 °F or lower

2. Warm up engine to normal operating temperature.
3. Drive vehicle at 30 - 40 mph, 50 - 60 kph for 2 min.
4. Stop vehicle and run engine at idle for 2 min.
5. Check DTC in "DTC" mode and pending DTC in "ON BOARD TEST" or "PENDING DTC" mode.

Inspection (Steps 1 - 4):