P0710

DTC P0710/DTC NO.36 OR 38 A/T FLUID TEMP. SENSOR CIRCUIT ELECTRICAL





WIRING DIAGRAM

CIRCUIT DESCRIPTION
The A/T fluid temperature is detected by the A/T fluid temp. sensor at A/T valves body assembly. TCM uses the signal from A/T fluid temp. sensor as one of the factors to control gear shift.





DTC DETECTING CONDITION AND TROUBLE AREA

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.

1. Turn ignition switch OFF.
2. Clear DTC stored in TCM and ECM.
3. Start engine and shift select lever to "D" range.
4. Drive vehicle for longer than 20 min.
5. Stop vehicle and then turn ignition switch OFF.
6. Repeat above step 3 and 4).
7. Check DTC and pending DTC.





TROUBLESHOOTING (DTC P0710/DTC NO. 36 OR 38)