P1717

Wiring Diagram:

CIRCUIT DESCRIPTION
Refer to A/T DRIVE RANGE (PARK/NEUTRAL POSITION) SIGNAL

Detecting Condition / Possible Cause:

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester.

1. Turn ignition switch OFF
2. Clear DTC with ignition switch ON.
3. Start engine and shift selector lever to "D" range.
4. Increase vehicle speed to higher than 20 mph, 32 kph and then stop vehicle.
5. Repeat above step 4) 9 times.
6. Shift selector lever to "2" range and repeat above step 4) and 5).
7. Shift selector lever to "L" range and repeat above step 4) and 5).
8. Check DTC in "DTC" mode and pending DTC in "ON BOARD TEST" or "PENDING DTC" mode.

Inspection (Steps 1 - 4):