Without Scan Tool

DTC CHECK
USING ABS WARNING LAMP





1. Using service wire, connect diagnosis switch terminal of DIAG-2 connector to ground.
2. Turn ignition switch to ON position.





3. Read flashing of ABS warning lamp, which represents DTC as shown in example and write it down. When more than 2 DTC's are stored in memory, deflection and flashing for each DTC is repeated three times starting with the smallest DTC number in increasing order.
For details of DTC, refer to Diagnostic Procedures.
Manufacturer Code Charts


NOTE:
^ ABS warning lamp indicates only DTC's described in "DTC Table", DTC12, which means that no malfunction DTC is stored and history DTC, which indicates history trouble area.
When there is a current trouble, ABS warning lamp remains ON and therefore DTC is not indicated.

4. After completing the check, turn ignition switch to OFF position and disconnect service wire from diagnosis connectors.