Differential

INSPECTION





1. Hold differential assembly with soft jawed vice and set special tools as shown.
Special Tools
(A): 09900-20606
(B): 09900-20701
2. Measure differential gear thrust play.
Differential gear thrust play: 0.06 - 0.18 mm (0.0024 - 0.0071 inch)
3. If thrust play is out of specification, replace differential case.

DIFFERENTIAL RING GEAR REMOVAL





1. Unclamp 4 ring gear set bolt lock plates.
2. Remove 8 bolts and 4 ring gear set bolt lock plates.

NOTE: Don't reuse lock plates.

3. Remove differential ring gear.

BEARING OUTER RACE REMOVAL





1. Remove differential side oil seal.

NOTE: Don't reuse removed oil seal.

2. Drive out taper roller bearing outer race and washer from transmission case by using special tools or like.
Special Tools
(A): 09924-74510
(B): 09924-74590
(C): 09924-84510-005

Bearing Outer Race Installation





1. Install bearing outer race and washer by using special tool and bummer.
Special Tools
(A): 09924-74510
(B): 09944-68210

DIFFERENTIAL RING GEAR INSTALLATION





1. Heat differential ring gear to about 100° C (212° F) in oil bath.
2. Clean mating surfaces of differential ring gear and differential case.





3. Install differential ring gear to differential case.
4. Install new 4 ring gear set bolt lock plates and 8 bolts and tighten bolts to specified torque.
Tightening Torque
(a): 99 Nm (9.9 kg-m, 72.0 ft. lbs.)
5. Clamp bolts with lock plate securely.





6. Install differential assembly to transmission case and tighten case bolts to specified torque.
Tightening Torque for transmission case 30 Nm (3.0 kg-m, 22.0 ft. lbs.)
7. Check preload of differential by using special tool.
Special Tool
(A): 09928-06050
Differential preload (starting torque)
1.0 - 1.4 Nm (0.1 - 0.14 kg-m, 0.74 - 1.01 ft. lbs.)

NOTE:
^ If preload exceeds specified value, reselect washer on both transmission case and housing.
^ Preload changes about 0.3 - 0.4 Nm (0.03 - 0.04 kg-m, 0.22 - 0.29 ft. lbs.) with each washer thickness.
^ Washer thickness: mm
2.35,2.40,2.45,2.50,2.55, 2.60, 2.65, 2.70, 2.75, 2.80, 2.85, 2.90, 2.10, 2.15, 2.20, 2.25, 2.30

8. Install differential side oil seal.