Counter Drive Gear

DISASSEMBLY





1. Clamp special tool in vise and place counter drive gear onto the special tool.
Special Tool
(B): 09927-76040





2. Unstake lock section of lock nut and remove lock nut using special tool.
Special Tool
(A): 09927-26010





3. Remove angular ball bearing from counter drive gear.

NOTE: If inner race of angular ball bearing remains on counter drive gear, remove it using gear puller and special tools.

Special Tools
(C): 09925-86010
(D): 09925-06010

ASSEMBLY





1. Press new angular ball bearing into counter drive gear using special tool.
Special Tool
(A): 09951 -46010
2. Temporally tighten new lock nut.





3. Clamp special tool in vise and place counter drive gear onto the special tool.
Special Tool
(B): 09927-76040





4. Tighten new lock nut using special tool until starting/rotation torques will be specifications with push-pull gauge or the like.
Special Tool
(A): 09927-26010
Specified value
Starting torque: 0.05 - 0.25 Nm (0.005 - 0.025 kg-m, 0.037 - 0.180 ft. lbs.)
Rotation torque: 0.05 - 0.15 Nm (0.005 - 0.025 kg-m, 0.037 - 0.108 ft. lbs.)





5. Stake new lock nut, using standard punch in combination with hammer.

NOTE: When staking lock nut, point a suitable staking tool toward axis center shaft and stake lock nut securely as shown in figure at left. (Poor staking may cause abnormal noise.)