Input Shaft and Counter Shaft

REMOVAL
1. Remove 3 gear shift fork shaft bolts with washers, then take out locating springs and steel balls.
2. Remove backup light switch.





3. Remove reverse shaft bolt with washer.
4. Remove transmission case outside bolts and clutch housing bolts.





5. Tapping left case flanges with plastic hammer, remove left case.
6. Pull out reverse gear shaft with washer, then take off reverse idler gear.





7. Pull out 5th and REV gear shift guide shaft together with 5th and REV gear shift shaft.

NOTE: When removing 5th and REV gear shift shaft and guide shaft, push up high speed gear shift shaft and shift it to 4th to facilitate removal of 5th and REV shifter.





8. Tapping input shaft end with plastic hammer, push it out as assembly from case a little, then take out input shaft assembly, counter shaft assembly, high speed gear shift shaft and low speed gear shift shaft all at once.
9. Remove countershaft L bearing cup from left case.
10. Remove differential side L oil seal also from left case.