Back Door Removal and Installation

Back Door Removal and Installation

Back Door Components:

Removal
1. Remove back door trim.
2. Disconnect wire harness (2) connector inside back door to take it out from door. As to vehicle provided with back window washer, disconnect washer hose (1).
3. Remove back door balancer lower (door side) fitting screws.
4. Remove door hinge bolts, and then door.







Installation
Reverse removal sequence noting the following points.
1. Securely connect coupler (1).







2. Adjust door latch striker so that striker shaft (2) approximately aligns with the center of groove of door latch (1).







3. Adjust door by rubber cushion (1).
Rubber cushion installed at each side of back door is of screw-adjustable type. Turn cushion to adjust door for proper position.