B1061

Wiring Diagram:

CAUTION:
- Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow table.
- When measurement of resistance or voltage is required in this table, use a specified digital multimeter (Refer to "Special Tool" in this section.) along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to"Inspection of Intermittents and Poor Connections" in this section.
- If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

DTC Will Set When
The voltage at the "AIR BAG" warning lamp circuit terminal "L70-30" does not match the commanded state of the warning lamp driver for specified time.

Test Description
STEP 1: This test rechecks "AIR BAG" warning lamp operation.
STEP 2: This test rechecks whether an abnormality is in SDM.

Step 1 - 2:

DTC Troubleshooting

NOTE:
Upon completion of inspection and repair work, perform the following items.
- Reconnect all air bag system components, ensure all components are properly mounted.
- Clear diagnostic trouble codes (Refer to "DTC Clearance"), if any.
- Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.