Keyless Entry Transmitter: Testing and Inspection

Programming Transmitter Code

NOTE:
- Four transmitter codes can be programmed at the same time.
- When fifth transmitter code is programmed, the oldest one will be cleared automatically.
- Program transmitter code(s) to be used in total four times to delete programmed transmitter code(s).

If transmitter / door lock controller is replaced with a new one or additional transmitter(s) is necessary, program transmitter code(s).
1. Confirm that all doors are closed and ignition key is out of ignition key cylinder
2. Open driver side door.
3. Insert ignition key into ignition key cylinder within 10 seconds after step 2).
4. Remove ignition key from ignition key cylinder within 10 seconds after step 3).
5. Push and release driver side door switch (1) 3 times by hand within 20 seconds after step 4).
6. Insert ignition key into ignition key cylinder within 10 seconds after step 5).
7. Remove ignition key from ignition key cylinder within 10 seconds after step 6).
8. Press and hold "LOCK" and "UNLOCK" buttons (2) on transmitter (3) for 5 seconds or more within 20 seconds after step 6) and confirm that all doors are operated from lock to unlock.
9. Press "LOCK" or "UNLOCK" button (2) transmitter (3) within 5 seconds after step 8) and confirm that all doors are operated from lock to unlock.
With this process, transmitter code has been programmed.

10. If you want to program the additional transmitter, repeat the procedure from Step 1) through Step 9).
11. Make sure that keyless entry system properly operates by operating programmed transmitter(s).