EVAP Canister Removal and Installation

EVAP Canister Removal and Installation

Removal

1) Hoist vehicle.
2) Disconnect purge hose (1) air valve hose (2) and refuel vapor control valve hose (3) from pipes.

For quick joint, disconnect it as follows:
a) Remove mud or dust around joint by blowing compressed air, and push joint fully in arrow direction (a).
b) Disconnect hose joint while joint lock is unlocked by pushing both sides of joint (b).
3) Disconnect air valve wire Harness connector.
4) Remove EVAP canister with bracket (4) from vehicle.
5) Remove EVAP canister from bracket.






Installation

EVAP Canister Inspection
1) Install EVAP canister to bracket.
2) Install EVAP canister with its bracket (1) to vehicle.





3) Connect air valve wire harness connector.
4) Connect purge hose, air valve hose and refuel vapor control valve hose to EVAP canister, and clamp then securely.

For quick joint, push joint into pipe till joint lock clicks.