With Manufacturer's Scan Tool

DTC Clearance
As automatic transaxle DTC is stored in memory of ECM and TCM respectively, be sure to clear it from both ECM and TCM by using either method-1 and method-2 or method-1 and method-3 of the following 3 methods.

To Clear DTC Stored in ECM With Scan Tool - Method-1
Refer to the same item in "DTC Clearance:" for reading procedure.

To Clear DTC Stored in TCM With Scan Tool - Method-2
1. Turn ignition switch OFF.





2. Connect SUZUKI scan tool to data link connector (DLC) (1) located In underside of instrument panel at driver's seat side.
Special tool
(A): SUZUKI scan tool
3. Turn ignition switch ON.
4. Clear DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
5. After completing the clearance, turn ignition switch OFF and disconnect SUZUKI scan tool from data link connector (DLC) (1).