Input Shaft Speed Sensor

Removal
1. Disconnect negative cable at battery.
2. Disconnect input shaft speed sensor connector (2).





3. Remove input shaft speed sensor (1) by removing its bolt.

Installation
1. Apply A/T fluid to input shaft speed sensor O-ring.
2. Install input shaft speed sensor (1) to A/T case and tighten bolt to specified torque.
Tightening torque
Input sham speed sensor bolt (a): 5.5 Nm (0.55 kgf-m, 4.0 ft. lbs.)





3. Connect input shaft speed sensor connector (2) to input shaft speed sensor (1).
4. Connect negative cable to battery.

Inspection
1. Disconnect negative cable at battery.
2. Disconnect input shaft speed sensor connector (2).





3. Check resistance between input shaft speed sensor (1) terminals.
Input shaft speed sensor resistance
Standard: 387 - 473 Ohms at 20°C (68°F)