Output Shaft Speed Sensor

Removal
1. Disconnect negative cable at battery.
2. Disconnect output shaft speed sensor connector (2).





3. Remove output shaft speed sensor (1) by removing its bolt.

Installation
1. Apply A/T fluid to output shaft speed sensor O-ring.
2. Install output shaft speed sensor (1) to A/T case and tighten bolt to specified torque.
Tightening torque
Output shaft speed sensor bolt (a): 5.5 Nm (0.55 kgf-m, 4-0 ft. lbs.)





3. Connect output shaft speed sensor connector (2) to output shaft speed sensor (1).
4. Connect negative cable to battery.

Inspection
1. Disconnect negative cable at battery.
2. Disconnect output shaft speed sensor connector (2).





3. Check resistance between output shaft speed sensor (1) terminals.
Output sham speed sensor resistance
Standard: 648 - 792 Ohms at 20°C (68°F)