Without Scan Tool
DTC CheckUsing "ABS" Warning Lamp
1. Using service wire, connect diag. switch terminal (4) of DIAG-2 connector (2) to ground.
2. Turn ignition switch to ON position.
3. Read flashing of "ABS" warning lamp which represents DTC as shown in example below and write it down. When more than 2 DTCs are stored in memory, deflection and flashing for each DTC is repeated three times starting with the smallest DTC number in increasing order. For details of DTC, refer to applicable DTC flow.
NOTE: "ABS" warning lamp indicates only DTCs described in "DTC Table: ", DTC 12 which means that no malfunction DTC is stored and history DTC which indicates history trouble area. When there is a current trouble, "ABS" warning lamp remains ON and therefore DTC is not indicated.
4. After completing the check, turn ignition switch to OFF position and disconnect service wire from diagnosis connectors.