Without Scan Tool

DTC Clearance

WARNING:
^ When performing a road test, select a safe place where there is neither any traffic accident possibility and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out with 2 persons, a driver and a tester, on a level road to avoid accident.

After repair or replace malfunction part(s), clear all DTCs by performing the following procedure.
1. Turn ignition switch OFF.
2. Using service wire (1), connect diag. switch terminal (2) of DIAG-2 connector (4) to ground terminal (3) of DIAG-1 connector (5).
3. With connection described in Step (2) maintained, turn ignition switch ON.
4. Repeat on/off operation of service wire at diag. ground terminal at least 5 times within 10 seconds.

NOTE: Service wire ON time must be for 0.1 second and more.





5. Turn ignition switch OFF and disconnect service wire from DIAG-2 connector.
6. Perform "Driving test" and "DTC check" and confirm that normal DTC (DTC 12) is displayed; not malfunction DTC.

NOTE: It is also possible to clear DTC by using SUZUKI scan tool. Refer to Cartridge Manual for procedure to clear DTC.