Without Scan Tool

DTC Check




Not Using SUZUKI Scan Tool
1. Turn "ON" ignition switch and wait about 20 seconds.
2. By using service wire, connect diag. switch terminal (3-1) and ground terminal (3-2) on "AIR BAG" monitor coupler (2).
3. To read DTC, watch "AIR BAG" warning lamp. For frequency of code signal, refer to the following figure.
If DTC is not indicated, check diagnosis switch circuit referring to ""AIR BAG" Warning Lamp Cannot Indicate DTC by Flashing".




EXAMPLE: When driver air bag initiator circuit resistance low (DTC No.22) is set

NOTE: When there are 2 or more DTC, all applicable code will be indicated from smaller number to large number in order.