Fluid - M/T: Service and Repair
Gear Oil Inspection and Change1. Before changing or inspecting oil, be sure to stop engine and lift vehicle horizontally.
2. With vehicle lifted up, check oil level and leakage. If leakage exists, correct it.
3. Drain old oil and fill new specified oil by specified amount (up to level hole).
4. Torque drain (1) and level/filler plugs (2) as specified. Apply sealant to thread of drain plug before installation.
"A": Sealant 99000-31110
Tightening torque
Oil drain and level/filler plug (a): 21 Nm (2.1 kgf-m, 15.5 ft. lbs.)
NOTE:
^ It is recommended to use API GL-4 75W-90 gear oil.
^ Whenever vehicle is hoisted for any other service work other than oil change, be sure to check for oil leakage.
Gear oil specification
Oil grade: API GL-4
Viscosity: SAE 75W-85, 75W-90 or 80W-90
Oil capacity: 2.2 liters (4.6/3.9 US/Imp.pt)