Input Shaft Speed Sensor

Removal
1. Disconnect negative cable at battery.
2. Disconnect input shaft speed sensor coupler.





3. Remove input shaft speed sensor (1) by removing its bolt.

Installation
1. Apply A/T fluid to input shaft speed sensor O-ring.





2. Install input shaft speed sensor (1) to A/T case and tighten bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 5.5 Nm (0.55 kgf-m, 4.0 ft. lbs.)
3. Connect input shaft speed sensor coupler to input shaft speed sensor.
4. Connect negative cable to battery.