B1016

Wiring Diagram:

CAUTION:
- Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow table.
- When measurement of resistance or voltage is required in this table, use a specified digital multimeter (Refer to "Special Tool".) along with a correct terminal adaptor from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to "Inspection of Intermittents and Poor Connections".
- If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

NOTE: If vehicle is equipped with driver or passenger side air bag ON-OFF switch, perform "Air Bag Diagnostic System Check Flow" with disconnecting air bag ON-OFF switch from air bag circuit. And if this DTC is not detected under the condition, replace air bag ON-OFF switch and recheck.

DTC Will Set When
The combined resistance of the passenger air bag (inflator) module, harness wiring and connector terminal contact is below a specified value for specified time.

Test Description
STEP 1: Check whether malfunction is in passenger air bag (inflator) module.
STEP 2: Check passenger air bag (inflator) module initiator circuit in air bag harness.

Step 1:

Step 2:

DTC Troubleshooting

NOTE:
Upon completion of inspection and repair work, perform the following items.
- Reconnect all air bag system components, ensure all components are properly mounted.
- Clear diagnostic trouble codes (Refer to "DTC Clearance"), if any.
- Repeat "Air Bag Diagnostic System Check"to confirm that the trouble has been corrected.