Operation CHARM: Car repair manuals for everyone.

Cylinder Block Heater (If Equipped) Removal and Installation







Cylinder Block Heater (If Equipped) Removal and Installation
Removal
1) Disconnect negative (-) cable battery.
2) Drain engine coolant.
3) Disconnect cylinder block heater connector and remove cylinder block heater (1).

Installation
Reverse removal procedure for installation, noting the following.





^ Install cylinder block heater (1) in the direction as shown in the figure.
^ Apply thread lock cement to block heater bolts (1).
"A": Thread lock cement 99000-32020





^ Tighten cylinder block heater bolts (1) to specified torque.
Tightening torque
Cylinder block heater bolt (a): 11 Nm (1.1 kgf-cm, 8.0 ft. lbs.)