CMP (Camshaft Position) Sensor Removal and Installation

CMP (Camshaft Position) Sensor Removal and Installation

CAUTION:

Disassembly is prohibited. If anything faulty is found, replace as an assembly unit.

Removal

1) Disconnect CMP sensor coupler.
2) Remove CMP sensor (1) by removing two bolts (2).






Installation

CMP (Camshaft Position) Sensor Inspection
1) Install a new O-ring (2) with engine oil applied to CMP sensor (1).





2) Install CMP sensor (1) to camshaft (3).

Fit the dog of CMP sensor coupling (2) into the slots of camshaft, when installing. The dogs of CMP sensor coupling are offset (A). Therefore, if the dogs can not be fitted into the slots, turn the CMP sensor shaft by 180 degree and try again.





3) Hand tighten CMP sensor (1) bolts (2) temporarily.
4) Connect CMP sensor coupler.

5) Check and adjust ignition timing according to Testing and Inspection Ignition Timing Inspection and Adjustment.
6) Tighten CMP sensor (1) bolts (2) to specified torque.

Tightening torque
CMP sensor bolt (a): 15 Nm (1.5 kgf-m, 11.0 lbf-ft)