Initial Inspection and Diagnostic Overview

Idle Air Control (IAC) Valve Inspection

Idle Air Control (IAC) Valve Removal and Installation
1) Disconnect connector from IAC valve.
2) Check for proper connection to IAC valve at each terminal.
3) Check IAC valve for resistance.

If check results are as specified in steps 2 and 3, proceed next step. If not, replace.

IAC valve resistance specification
Between two terminals: 8.6 - 10.6 ohms at 20 °C, 68 °F
Between terminal and valve body: Infinity





4) Connect connector to IAC valve.
5) Warm up engine to normal operating temperature.
6) Disconnect connector from IAC valve and check engine idle speed.





7) Connect 12 V-battery (1) to IAC valve as shown in figure with engine running and check engine idle speed.

Engine idle speed observed in step 7 should be higher than engine idle speed observed in step 6.

If check result is not specified, replace IAC valve.

CAUTION:
Wrong connection cause IAC valve to burn, connect each wire to correct terminal.