Instruments - L/H or R/H Door Mirror Loose

Section Title: Body, Cab & Accessories

TSB No. TS 06 12144

Division: Automotive

Category: Technical

SUBJECT:
DRIVER AND/OR PASSENGER SIDE MIRROR LOOSE

MODEL(S):
AERIO (RH420/RH423)

YEAR(S):
2002-2004

CONDITION:
Driver and/or passenger side mirror(s) are loose at the break away pivot.

CAUSE:
The three screws that attach the mounting bracket to the mirror assembly break away pivot are loose.

CORRECTION:
Replace the three old mirror screws with new screws. See the part number listed below in parts information table. Follow the instructions listed below, to remove the affected mirror assembly and replace the screws.

NOTE:
Use Loctite(R) 648 or 271 (648 is preferred), on the threads of the new screws before installing.





PARTS INFORMATION





WARRANTY CLAIM INFORMATION

Screw Replacement Instructions





1. Fold mirror so mirror is against the window. Pry bolt cover access off with a small pocket flat head screwdriver where indicated by arrow.





2. Remove the two exterior mounting bolts.





3. Working on the inside of the door, remove the plastic cover to reveal the last mounting bolt. Carefully remove the bolt as it can easily drop inside the door.





4. Carefully pull the mirror assembly away from the door and turn it upside down to reveal the three screws that will be replaced. It is not necessary to disconnect the wire for this procedure.





5. Remove and replace each of the three screws one at a time and replace them with the new screws. Be sure to apply the above listed Loctite(R) to the threads before installing.

6. Reinstall mirror assembly to vehicle door(s).





NOTE:
Replacement screw (09139-05063) sample picture.





Disclaimer