Selector Cable Adjustment

Selector Cable Adjustment
1. Remove adjuster (cable end) from selector lever pin of selector lever assembly.





2. Shift manual shift lever to "N" range (transmission range sensor "N" range).





3. Release lock plate (1) which restrict moving of cable end holder (2).





4. Push cable end holder (1) out from eye-end (2) using an appropriate tool (3) to disengage cable.
5. Shift selector lever to "N" position.
6. Apply grease to selector lever pin and install adjuster (cable end) to it.
Grease 99000-25010
7. With both selector lever and transmission range sensor kept each "N" position, drive cable end holder (1) in until it locks cable.





8. Slide lock plate (2) to secure cable end holder in position.
9. After select cable was installed, check for the following.
^ Push vehicle with selector lever shifted to "P" range.
^ Vehicle should not move.
^ Vehicle can not be driven in "N" range.
^ Vehicle can be driven in "D", "2" and "L" ranges.
^ Vehicle can be backed in "R" range.