10. Gear Shift and Select Shaft Disassembly and Assembly
Gear Shift and Select Shaft Disassembly and Assembly1. To disassemble component parts, use special tools and 2.8 - 3.0 mm (0.11 inch) pin remover in addition.
Special Tool
(A): 09922-85811 (4.5 mm)
(B): 09925-78210 (6.0 mm)
2. Clean all parts thoroughly, inspect them and replace with new ones as required.
3. Assemble component parts by reversing removal procedure.
NOTE:
^ When driving in spring pins, prevent shaft from being bent by supporting it with wood block.
^ Assemble 5th & reverse gear shift cam (13) by winding cam guide return spring, and then drive in spring pin.
^ Locate low speed select spring (White-Lower position) and reverse select spring (Pink-Upper position) correctly.