Operation CHARM: Car repair manuals for everyone.

6. Right Case Installation

Right Case Installation
1. If reverse gear shift lever (1) has been removed, fasten it with 2 bolts after applying thread lock cement with distance "a" between lever end and shaft bore set to specified value.
Distance between lever end and shaft bore "a": 5 mm (0.2 inch)
"A": Cement 99000-32110
Tightening torque
Reverse gear shift lever bolts (a): 23 Nm (2.3 kgf-cm, 17.0 ft. lbs.)

NOTE:
^ Distance "a" can be measured by installing reverse gear shaft provisionally.
^ When "a" is 5 mm (0.2 inch), clearance between reverse idler gear groove and shift lever end will be 1 mm (0.04 inch).

2. Install input shaft oil seal (2) facing its spring side upward. Use special tool and hammer for installation and apply grease to oil seal lip.
"B": Grease 99000-25010
Special Tool (A): 09913-84510





3. Install countershaft right bearing cup (3) by using special tools and hammer.
Special Tool
(B): 09913-75821
(C): 09924-84510-004





4. Install input right bearing (1) by using special tool and hammer.
Special Tool
(A): 09913-76010





5. Install input right bearing (1) stopper plate (2) and b9lt (3) applied with thread lock cement.
"A": Thread lock cement 99000-32110
Tightening torque
Input right bearing stopper plate bolt (a): 10 Nm (1.0 kgf-cm, 7.5 ft. lbs.)