Rear Door Window Glass: Service and Repair
Rear Door Glass Removal and InstallationRear Door Window Components:
Removal
1. Remove inside handle bezel (1).
2. Remove inside door grip cover (2), and then remove door trim mounting bolts (3).
3. Remove door trim mounting clip.
4. Remove door trim (1).
With inside handle bezel (2) tilted as shown.
And disconnect power window switch lead wire at coupler.
5. Remove door sealing cover (1).
6. Remove outer weather-strip (1). Do not deform it when removal.
7. Loosen door glass mounting screws (1), and then drop door glass (2) from window regulator (3).
8. Detach rear part of glass run from sash (4), and remove sash by removing 2 screws (5) and bolt (6).
9. Remove door glass (2).
Installation
Reverse removal procedure noting the following instructions.
- If there is deformity for glass run, replace new one.
- Tighten door glass rear mounting screw (1) first, and then tighten door glass front mounting screw (2).
- Tighten rear door rear sash lower mounting bolts (1), and tighten rear door rear sash upper mounting screws (2, 3) as specified torque.
Tightening order: (1) -> (2) -> (3)
Tightening torque
Rear door rear sash upper mounting screw (a): 2.5 N.m (0.25 kg-m, 1.8 lbf-ft)
- Secure door sealing cover (1) with adhesive (2).
- Tighten rear door outer weather-strip mounting screw to specified torque.
Tightening torque
Rear door outer weather-strip mounting screw (a): 1.5 N.m (0.15 kg-m, 1.0 lbf-ft)
