C1041

DTC C1041 / C1045 / C1051 / C1055, C1042 / C1046 / C1052 / C1056 (No.41 / 45 / 51 / 55, No.42 / 46 / 52 / 56): Right-Front / Left-Front / Right-Rear / Left-Rear Inlet Solenoid Circuit, Right-Front / Left-Front / Right-Rear / Left-Rear Outlet Solenoid Circuit

Wiring Diagram










DTC Detecting Condition

The ABS control module monitors the output from the valve.

When the output of each valve exceeds the specified value compared with the signal sent from ABS control module, this DTC is set.

DTC Troubleshooting

1. Check solenoid operation referring to item ABS Hydraulic Unit Operation Check.

Is it in good condition?
YES
Check terminal "E15-25" connection. If connection is OK, substitute a known-good ABS hydraulic unit/control module assembly and recheck.
NO
Go to Step 2.

2. Ignition switch OFF.
Disconnect ABS hydraulic unit/control module connector.
Check for proper connection to ABS hydraulic unit/control module connector at terminal "E15-25".
If OK, then measure voltage between terminal "E15-25" of module connector and "E15-24" or "E15-22".

Is it 10 - 14 V?
YES
Substitute a known-good ABS hydraulic unit/control module assembly and recheck.
NO
"WHT/BLU" or "BLK" circuit open.