DTC 37

DTC P0717 (No.37): Input / Turbine Speed Sensor Circuit No Signal

Wiring Diagram

DTC Detecting Condition and Trouble Area

DTC Confirmation Procedure

WARNING:

- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.

1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using scan tool and start engine.
3) Shift selector lever to "D" range and drive vehicle at 30 km/h (19 mile/h) or more vehicle at least for 60 seconds.
4) Stop vehicle.
5) Check DTC, pending DTC and freeze frame data.

DTC Troubleshooting

1.
Was "A/T System Check" performed?
YES
Go to Step 2.
NO
Go to A/T System Check.

2. Check input shaft speed sensor circuit

Disconnect TCM connectors with ignition switch OFF.
Check for proper connection to input shaft speed sensor at "G07-5" and "G07-17" terminals.
If OK, check resistance of sensor circuit.

Resistance of input shaft speed sensor circuit
Between terminals "G07-5" and "G07-17" of disconnected harness side TCM connector: 387 - 475 ohms at 20 °C (68 °F)
Between terminal "G07-5" / "G07-17" of disconnected harness side TCM connector and ground: No continuity

Are check result satisfactory?
YES
Go to Step 4.
NO
Go to Step 3.

3. Inspect input shaft speed sensor

1) Inspect input shaft speed sensor referring to Input Shaft Speed Sensor Inspection.

Is result satisfactory?
YES
"RED" or "GRN" circuit open or short.
NO
Replace input shaft speed sensor.

4. Check visually input shaft speed sensor and forward clutch drum using mirror for the following

- No damage
- No foreign material attached
- Correct installation

Are they in good condition?
YES
Intermittent trouble or faulty TCM.
Check for intermittent referring to Intermittent and Poor Connection Inspection.
If OK, substitute a known-good TCM and recheck.
NO
Clean, repair or replace.