Clearing Codes
DTC ClearanceAs automatic transaxle DTC is stored in memory of ECM and TCM respectively, be sure to clear it from both ECM and TCM by using either method-1 and method-2 or method-1 and method-3 of the following 3 methods.
To Clear DTC Stored in ECM with Scan Tool - Method-1
Refer to the same item in DTC Clearance for reading procedure.
To Clear DTC Stored in TCM with Scan Tool - Method-2
1. Turn ignition switch OFF.
2. Connect SUZUKI scan tool to Data Link Connector (DLC) (1) located In underside of instrument panel at driver's seat side.
Special Tool (A): SUZUKI scan tool (Tech 2 kit)
3. Turn ignition switch ON.
4. Clear DTC. Refer to SUZUKI scan tool operator's manual for further details.
5. After completing the clearance, turn ignition switch OFF and disconnect SUZUKI scan tool from Data Link Connector (DLC) (1).
To Clear DTC Stored in TCM Without Scan Tool - Method-3
1. Remove glove box (1) from instrument panel.
2. Turn ignition switch ON.
3. After 6 seconds or more, repeat connecting and disconnecting diagnosis switch terminal (3) and ground terminal (4) of monitor connector (color in Blue) (2) 5 times at about 1 second interval within 10 seconds, using service wire.
4. Check TCM that no malfunction DTC remains in memory of it.