Body - Sunroof Won't Close/Opens to Vent Position
VERONASection Title: Body, Cab & Accessories
TSB No. TS 03 05115R
Division: Automotive
Category: Technical
SUBJECT:
SUNROOF WILL NOT CLOSE COMPLETELY OR CLOSES AND MOVES TO VENT POSITION
MODEL(S):
VERONA
YEAR:
2004
REVISION:
Defect Code and Complaint Code corrected.
CONDITION:
The sunroof may not close completely or after reaching closed position does not stop and continues to operate until the vent position is reached.
CAUSE:
This condition may occur when the Sunroof Control Unit (SCU) experiences a loss of its memorized position data.
CORRECTION:
Re-calibrate the SCU. Please follow the service procedure listed below.
SCU Recalibration Procedure
1. Push and hold the rear part of the sunroof switch to open the sunroof fully. Release the switch when the sunroof has fully opened. If the sunroof opens slightly and stops, release, then push the switch and hold it. Repeat this until the sunroof opens fully.
NOTE:
In the next step, you must push and hold the front part of the sunroof switch until the sunroof does not move.
2. Push and hold the front part of the sunroof switch to close the sunroof fully.
3. Push the front part of the sunroof switch again and hold it until the sunroof clicks and slight movement occurs. This click should occur within 10 seconds.
4. Confirm the recalibration procedures by verifying that the sunroof opens and closes properly.
WARRANTY CLAIM INFORMATION:
Disclaimer