Steering Wheel: Service and Repair

Steering Wheel

Removal

Tools Required:
KM-210-A Steering Wheel Puller

1. Disconnect the negative battery cable.
2. Remove the SIR module.





3. Remove the steering wheel nut and the retaining clip.
4. Remove the steering wheel using the steering wheel puller KM-210-A.

CAUTION: In order to install the steering wheel correctly, match-mark the steering column shaft to the steering wheel.

Special Tools And Equipment:

5. Unclip the contact ring from the steering wheel, if necessary.

Installation
1. Clip the contact ring on the steering wheel, if necessary.
2. Align the match marks on the steering wheel and the steering column shaft. Turn the signal canceling cam on the wheel to the left.

CAUTION: In order to correctly install the steering wheel, match-mark the steering column shaft to the steering wheel.

3. Install the retaining clip and the steering wheel nut.
Tighten: Tighten the steering wheel nut to 38 Nm (28 ft. lbs.).
4. Bend the tabs to secure the retaining clip.
5. Install the SIR module.





6. Connect the negative battery cable.