"Air Bag" Warning Lamp Cannot Indicate Flashing Pattern of DTC

"AIR BAG" Warning Lamp Cannot Indicate Flashing Pattern of DTC

Wiring Diagram:

wiring diagram

CAUTION:
- Be sure to perform Air Bag Diagnostic System Check before starting diagnosis according to flow.
- When measurement of resistance or voltage is required in this flow, use a tester along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to Inspection of Intermittent and Poor Connections.
- If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

Flow Test Description

Step 1 - 2:

Step 1: Check "AIR BAG" monitor coupler.
Step 2: Check diagnosis switch circuit for air bag system.

NOTE: Upon completion of inspection and repair work, perform the following items.
- Reconnect all air bag system components and ensure all components are properly mounted.
- Repeat Air Bag Diagnostic System Check to confirm that the trouble has been corrected.