DTC 17

DTC P0751 / P0752 / P0756 / P0757 (No. 17 / No. 17 / No. 28 / No. 28): Shift Solenoid-A (No. 1) Performance or Stuck OFF / Shift Solenoid-A (No. 1) Stuck ON / Shift Solenoid-B (No. 2) Performance or Stuck OFF / Shift Solenoid-B (No. 2) Stuck ON

DTC Detecting Condition and Trouble Area

DTC Detecting Condition and Trouble Area:

DTC Confirmation Procedure

WARNING:
^ When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out with 2 persons, a driver and tester, on a level road.

1. Connect scan tool to DLC with ignition switch OFF.
2. Clear DTCs in TCM and ECM memories by using scan tool.
3. Start engine and warm it up to normal operating temperature.
4. Turn O/D off switch OFF. (Confirm O/D OFF lamp does not light.)
5. Shift selector lever to D range and hold it for 20 seconds or longer.
6. Drive vehicle with 2nd, 3rd and 4th gear in D range in that order at 15 km/h (10 mile/h) or more for longer than 10 seconds each referring to Automatic Gear Shift Table (for 2WD Model) or Automatic Gear Shift Table (for 4WD Model).
7. Stop vehicle and turn ignition switch OFF.
8. Report Step 3) to 6) one time.
9. Stop vehicle.
10. Check DTC, pending DTC and freeze frame data.

DTC Troubleshooting

Steps 1-2: