Operation CHARM: Car repair manuals for everyone.

Without ORVR

DTC P0138 : O2 Sensor Circuit Low / High Voltage (Sensor-2) (For Vehicle without ORVR)

Wiring Diagram:




Wiring Diagram




DTC Detecting Condition and Trouble Area

DTC Confirmation Procedure

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.

NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temp.: between -10 degrees C and 70 degrees C (14 degrees F and 158 degrees F)
- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)

1. With ignition switch turned OFF, connect scan tool.
2. Turn ON ignition switch and clear DTC using scan tool.
3. Start engine and warm up to normal operating temperature.
4. Increase vehicle speed to 40 mph (60 km/h) or more. (engine speed: 2500 - 3000 r/min.)
5. Keep the vehicle speed for 10 min. or more. (Throttle valve opening is kept constant in this step.)
6. Release accelerator pedal and with engine brake applied, keep vehicle coasting (with fuel cut for 4 sec. or more), then stop vehicle and run engine at idle speed for 6 sec. or more.
7. Check DTC and pending DTC.

Step 1 - 2:




Step 3 - 5:




Step 6 - 11:




DTC Troubleshooting