P1717
DTC P1717: A/T Driver Range Signal Circuit MalfunctionWiring Diagram:
Wiring Diagram
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester.
1. Turn OFF ignition switch and connect scan tool to DLC.
2. Clear DTC with ignition switch turned ON.
3. Start engine and shift select lever to "D" range.
4. Increase vehicle speed to higher than 25 mph, 40 km/h and then stop vehicle.
5. Repeat step 4 nine times.
6. Shift selector lever to "2" range and repeat Step 4 and 5.
7. Shift selector lever to "L" range and repeat Step 4 and 5.
8. Check DTC and pending DTC.
Step 1 - 2:
Step 3 - 6:
DTC Troubleshooting