With Manufacturer's Scan Tool

DTC Clearance

NOTE: Only history DTC(s) can be cleared. Current DTC(s) can not be cleared unless the problem(s) is fixed.

Using SUZUKI Scan tool
1. Turn ignition switch to OFF position.
2. Connect SUZUKI scan tool to data link connector (DLC) (1) located on underside of instrument panel at driver's seat side.




Special Tool
(A): SUZUKI scan tool

3. Light over sunload sensor vertically with an incandescent lamp approximately 60 W apart from about 100 mm (3.94 in.).

NOTE: If sunload sensor is not lighted over with an incandescent lamp, DTC B1504 is detected as current DTC even though there is not any malfunction.

4. Turn ignition switch to ON position.
5. Erase DTC according to instructions displayed on SUZUKI scan tool.

NOTE: To know how to use SUZUKI scan tool, refer to operator's manual for SUZUKI scan tool.

6. After completing the clearance, turn ignition switch to OFF position, and then disconnect SUZUKI scan tool from DLC.