Rear

Wheel Hub, Wheel Bearing and Wheel Stud Removal and Installation

Removal
1. Remove rear brake drum.





2. Remove spindle cap (1) as shown (by hammering lightly at 3 locations around it so as not to deform or cause damage to seating part of cap).
3. Uncaulk spindle nut and remove spindle nut (2).





4. Pull wheel hub (1) off by using special tools.
Special tool
(A): 09943-17912
(B): 09942-15511
5. Remove wheel sensor ring (if equipped with ABS).
6. Remove hub bolts.

Installation
1. Install hub bolts.





2. Install wheel hub (1) and new spindle nut.
3. Tighten spindle nut (2) to specified torque.

NOTE: Removed spindle nut should be replaced with new one.

Tightening torque
Spindle nut (a): 175 Nm (17.5 kgf-m, 126.5 ft. lbs.)





4. Caulk spindle nut (1) as shown.
5. Install new spindle cap.

NOTE: When installing spindle cap, hammer lightly several locations on the collar of cap until collar comes closely into contact with wheel hub.

6. Install brake drum and wheel.