15. Reverse Clutch Inspection

Part 1 Of 2:

Part 2 Of 2:

Reverse Clutch Inspection





1. Check that sliding surfaces of friction, separator and cushion plates are not worn or burnt. If necessary, replace.

NOTE:
^ If friction plate lining is exfoliated, discolored or worn hardly, replace all friction plates.
^ Before assembling new friction plates, soak them in A/T fluid for at least two hours.





2. Measure height of reverse clutch return spring.
Reverse clutch return spring height
Standard: 18.7 mm (0.74 inch)

NOTE: Do not apply excessive force when measuring spring height. Perform measurement at several points.





3. Make sure that ball (1) makes creaking noise when shaking the reverse clutch piston. (i.e., check that ball is free.)
4. Check that there is no leakage by applying low-pressure air onto ball.





5. Check that outer surface of reverse clutch with bearing is not worn or burnt. If necessary, replace.