Rear Mounting Removal and Installation
Rear Differential Rear Mounting Removal and InstallationRemoval
1. Hoist vehicle.
2. Remove stabilizer bar mount bolt (1) and stabilizer bar bracket (2) installed on right side of vehicle.
3. Place jack (1) under rear differential.
4. Remove mounting bracket bolts (2), mounting bolts (3) and differential rear mounting (4).
5. Drive mountings out with special tools and hydraulic press (1).
Special Tool
(C): 09951-16080
(D): 09951-26020
Installation
1. Press mountings (1) in rear mounting bracket (2) by using special tools and hydraulic press (3) with caring its installation position shown in figure.
Special Tool
(C): 09951-16080
(D): 09951-26020
2. Install differential rear mounting (4), and tighten mounting bracket bolts (5) and mounting bolts (6) to specified torque.
Tightening torque
Differential front mounting bracket bolts (a): 50 Nm (5.0 kgf-cm, 36.5 ft. lbs.)
Differential front mounting bolt (b): 80 Nm (8.0 kgf-cm, 58.0 ft. lbs.)
3. Install stabilizer bar bracket (1) and tighten stabilizer bar mount bolt (2) to specified torque.
Tightening torque
Stabilizer bar mount bolt (a): 23 Nm (2.3 kgf-cm, 17.0 ft. lbs.)