Removal and Replacement
Rearend Door Glass (for Wagon Model) Removal and InstallationRearend Door Window (For Wagon Model) Components:
Refer to Windshield Removal and Installation as removal and installation procedures are basically the same. However, note the following.
^ Observe the following precautions when applying adhesive (1) along glass (2) edge.
^ Adhesive (1) should be applied evenly especially in height.
^ Be careful not to damage primer (3).
^ With the position of fastener (4) properly aligned, install glass (2) on rear end door panel (5).
^ Press glass against body quickly after adhesive (1) is applied.
Adhesive amount specifications and position for back door glass
Height "a": 14 mm (0.55 in.)
Width "b": 7 mm (0.28 in.)
Width "c": 16 mm (0.63 in.)
Position "d": 14 mm (0.55 in.) for glass upper and side sections
Position "d": 15 mm (0.59 in.) for glass bottom section
