Rear Wiper Motor (If Equipped) Inspection

Rear Wiper Motor (If Equipped) Inspection

NOTE: Make sure that battery voltage is 12 V or more.

Motor Operation
1. Connect battery positive terminal to terminal "L" and its negative terminal to terminal "E".
2. Check motor revolution speed as specification. If check result is not as specified, replace motor.

Specification: 35 - 45 r/min (rpm)

Automatic Stop Operation




1. Connect battery positive (+) terminal to terminal "L" and its negative (-) terminal to terminal "E" and let the motor turn.
2. Disconnect terminal "L" from battery positive (+) terminal and let the motor stop.
3. Connect terminal "B" to battery positive (+) terminal. Observe the motor turns once again then stops at a specified position.
4. Repeat Step 1) to 3) several times and check that the motor stops at the specified position every time.
If check result is not satisfied, replace motor.