Transmission Position Sensor/Switch: Service and Repair

Park/Neutral Start Switch Removal and Installation

Removal
1. Disconnect the negative battery cable.
2. Disconnect the park/neutral position switch electrical connector.





3. Disconnect the shift control cable and the retaining clip.





4. Remove the shift lever nut and the shift lever.





5. Remove the park/neutral start switch.

Installation

Tools Required: DW260-050 P/N Switch Installer

1. Install the park/neutral start switch.
^ Tighten the bolts to 10 Nm (89 inch lbs.).





2. Adjust the park/neutral switch using the P/N switch installer DW260-050.





3. Install the shift lever and the shift lever nut.
^ Tighten the shift lever nut to 10 Nm (89 inch lbs.).
4. Connect the shift control cable and the retaining clip.
5. Connect the park/neutral position switch electrical connector.





6. Connect the negative battery cable.