Brake F, Slotted Nut Disassembly and Assembly and Installation
Brake F, Slotted Nut Disassembly and Assembly and InstallationTools Required:
DW260-060 Brake F Split Stop Ring Remover
1. Remove the side shaft.
2. Take OFF the disc set and the brake F inner disc carrier.
3. Mount fixture and remove the brake F split stop ring.
4. Remove the fixture and take off the cup spring.
5. Release the piston F by applying compressed air to the bore.
6. Remove piston F and bearing plate with spur gear.
7. Installation should follow the removal procedure in the reverse order.
Measuring Installation Space F
Tools Required:
DW260-110 Brake F Disc Clearance Measuring Bar
1. Using a depth gauge, measuring from the transaxle housing sealing surfaces to the piston's disc support surface at two opposing points = M1, M2
2. Average the measurement values M1, M2 = BF
^ CALCULATION
BF = (M1 + M2)/ 2
^ EXAMPLE
M1 = 18.6 mm
M2 = 18.8 mm
BF = 18.7 mm
Determining Adjusting Disc F
1. Calculate the test dimension PF (PF = BF - MF)
BF = installation space
MF = disc set thickness (assume 14.50 mm)
^ EXAMPLE
BF = 18.70 mm
MF = 14.50 mm
PF = 4.2 mm
2. Find the disc set's thickness.
PF is 4.20 mm so, the disc set's thickness is 3.0 mm.
3. Replace clutch B's setting disc. (3.0 mm)