With Automatic A/C
Automatic Temperature Control AssemblyRemoval
1. Disconnect the negative battery cable.
2. Remove the audio trim panel. Refer to Instrument Cluster Trim Panel Removal.
3. Remove the control assembly retaining screws.
4. Pull out the unit to gain access to the rear.
5. Disconnect the electrical connectors.
6. Remove the air inlet tube.
7. Remove the automatic temperature control assembly.
Installation
1. Connect the air inlet tube.
2. Connect the electrical connectors.
3. Position the automatic temperature control assembly and install the retaining screws.
Tighten: Tighten the control assembly retaining screws to 2.5 N.m (22 lb-in.).
4. Install the audio trim panel. Refer to Instrument Cluster Trim Panel Installation.
5. Connect the negative battery cable.