Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor Removal and Installation

Removal
1. Disconnect the negative battery cable.




2. Remove the air filter outlet hose.




3. Disconnect the crankshaft position (CKP) sensor wiring harness connector.




4. Remove the crankshaft position (CKP) sensor heat shield housing.




5. Remove the CKP sensor.

Installation
1. Installation should follow the removal procedure in the reverse order.




2. Install the crankshaft position (CKP) sensor.

Tighten: Tighten the CKP sensor retaining bolt to 5 - 8 N.m (44 - 71 lb-in.).




3. Install the CKP sensor heat shield housing.

Tighten: Tighten the CKP sensor heat shield housing bolt to 7 - 9 N.m (62 - 80 lb-in.).