Vehicle Damage Warnings

Basic Knowledge Required
You must be familiar with some basic electronics to use this section of the Service Manual. They will help you to follow diagnostic procedures.

CAUTION: Lack of the basic knowledge of this transaxle when performing diagnostic procedures could result in incorrect diagnostic performance or damage to transaxle components.

Do not, under any circumstances, attempt to diagnose a transaxle problem without this basic knowledge.

CAUTION: If a wire is probed with a sharp instrument and not properly sealed afterward, the wire will corrode and an open circuit will result.

Diagnostic test probes are now available that allow you to probe individual wires without leaving the wire open to the environment. These probe devices are inexpensive and easy to install, and they permanently seal the wire from corrosion.

Special Tools
You should be able to use a Digital Volt Meter (DVM), a circuit tester, jumper wires or leads and a line pressure gauge set.
The functional check procedure is designed to verify the correct operation of electronic components in the transaxle.
This will eliminate the unnecessary removal of transaxle components.