Restraints - Except Advanced Air Bag

DTC B1064 / B1066: Side Sensor (Driver / Passenger Side) Circuit Short to Power Circuit or Open

Wiring Diagram:

Wiring Diagram

CAUTION:
- Be sure to perform Air Bag Diagnostic System Check: Except Advanced Air Bag before starting diagnosis according to flow table.
- When measurement of resistance or voltage is required in this table, use a specified digital multimeter (Refer to Special Tool: Except Advanced Air Bag.) along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to Inspection of Intermittents and Poor Connections: Except Advanced Air Bag.
- If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

DTC Will Set when
The voltage measured at side sensor (driver or passenger side) circuit is above a specified value for specified time.

Flow Test Description
Step 1: Check side sensor (driver or passenger side) circuit in floor harness.
Step 2: Check side sensor (driver or passenger side) circuit in floor harness.

Step 1-2:

Step 2 (Continued):

DTC Troubleshooting

NOTE: Upon completion of inspection and repair work, perform the following items.
- Reconnect all air bag system components, ensure all components are properly mounted.
- Clear diagnostic trouble codes (Refer to DTC Clearance: Except Advanced Air Bag), if any.
- Repeat Air Bag Diagnostic System Check: Except Advanced Air Bag to confirm that the trouble has been corrected.