DTC 1062

DTC B1062 / B1066 (No.1062 / 1066): Side Air Bag (Driver / Passenger Side) Initiator Circuit Resistance Low

Wiring Diagram:

Wiring Diagram

CAUTION:
- Be sure to perform Air Bag Diagnostic System Check: Advanced Air Bag before starting diagnosis according to flow.
- When measurement of resistance or voltage is required in this flow, use a specified digital multimeter (Refer to Special Tool: Advanced Air Bag.) along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to Inspection of Intermittent and Poor Connections: Advanced Air Bag.
- If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

DTC Will Set when
The combined resistance of the side air bag (inflator) module (driver or passenger side), harness wiring and connector terminal contact is below a specified value for specified time.

Flow Test Description
Step 1: Check whether malfunction is in side air bag (inflator) module.
Step 2: Check side air bag initiator circuit in floor harness.
Step 3: Check side air bag initiator circuit in seat harness.

Step 1-2:

Step 2 (Continued)-3:

Step 3 (Continued):

DTC Troubleshooting

NOTE: Upon completion of inspection and repair work, perform the following items.
- Reconnect all air bag system components, ensure all components are properly mounted.
- Clear DTCs referring to DTC Clearance for SDM: Advanced Air Bag and DTC Clearance for OCM: Advanced Air Bag, if any.
- Repeat Air Bag Diagnostic System Check: Advanced Air Bag to confirm that the trouble has been corrected.